Question
Convex lens is not used in:

Answer

  1. Flood lights
Explanation:
Convex lens always converges the parallel rays but in flood lights, we want to diverge the incident rays so as to light up more area. Thus we use a diverging lens i.e. a concave lens. Thus a convex lens is not used in flood lights.

Need a full question paper?

Generate a complete, print-ready paper with questions like this in minutes — across 16+ boards, with answer keys.

Start Generating Free

Similar questions

For the given combination of gates, if the logic states of inputs A, B, C are as follows A = B = C = 0 and A = B = 1,C = 0 then the logic states of output D are:
The rays of different colours fail to converge at a point after going through a converging lens. This defect is called:
Give the $SI$ unit of magnetic dipole moment.
A small coil $C$ with $N = 200$ turns is mounted on one end of a balance beam and introduced between the poles of an electromagnet as shown in figure. The cross sectional area of coil is $A= 1.0 \ cm^2,$ length of arm $OA$ of the balance beam is $l = 30 \ cm$. When there is no current in the coil the balance is in equilibrium. On passing a current $I = 22\ mA$ through the coil the equilibrium is restored by putting the additional counter weight of mass $\triangle m = 60\ mg$ on the balance pan. Find the magnetic induction at the spot where coil is located.
Point charges $+4 q,-q$ and $+4 q$ are kept on the $X$-axis at points $x=0, x=a$ and $x=2$ a respectively:
The pressure p and volume V of an ideal gas both increase in a process.
  1. Such a process is not possible.
  2. The work done by the system is positive.
  3. The temperature of the system must increase.
  4. Heat supplied to the gas is equal to the change in internal energy.
An LR circuit with a battery is connected at t = 0. Which of the following quantities is not zero just after the connection?
  1. Current in the circuit.
  2. Magnetic field energy in the inductor.
  3. Power delivered by the battery.
  4. Emf induced in the inductor.
A point source of light is used in a photoelectric effect. If the source is removed farther from the emitting metal, the stopping potential:
  1. Will increase.
  2. Will decrease.
  3. Will remain constant.
  4. Will either increase or decrease.
The example of non-ohmic resistance is:
When a photon stimulates the emission of another photon, the two photons have:
  1. Same energy.
  2. Same direction.
  3. Same phase.
  4. Same wavelength.
  5. All of the above