MCQ
In a projectile motion, velocity at maximum height is
- A$\frac{u \cos \theta}{2}$
- ✓$u \cos \theta$
- C$\frac{u \sin \theta}{2}$
- DNone of these
✓
Answer
Correct option: B.
$u \cos \theta$
(b) Only horizontal component of velocity $(u \cos \theta)$.
Need a full question paper?
Generate a complete, print-ready paper with questions like this in minutes — across 16+ boards, with answer keys.
Explore more
Similar questions
Diamagnetic substances are
The approximate ratio of resistances in the forward and reverse bias of the $P N$-junction diode is
→Triple point of water is
The position vectors of points $A, B, \quad C$ and $D$ are $A=3 \hat{i}+4 \hat{j}+5 \hat{k}, B=4 \hat{i}+5 \hat{j}+6 \hat{k}, C=7 \hat{i}+9 \hat{j}+3 \hat{k} \quad$ and $D=4 \hat{i}+6 \hat{j}$ then the displacement vectors $A B$ and $C D$ are
→A body is at rest under the action of three forces, two of which are $\vec{F}_1=4 \hat{i}, \vec{F}_2=6 \hat{j}$, the third force is
→Any vector in an arbitrary direction can always be replaced by two (or three)
A small coil C with $N=200$ turns is mounted on one end of a balance beam and introduced between the poles of an electromagnet as shown in figure. The cross sectional area of coil is $A=1.0 \mathrm{~cm}$, length of arm OA of the balance beam is $l=30 \mathrm{~cm}$. When there is no current in the coil the balance is in equilibrium. On passing a current $I=22 \mathrm{~mA}$ through the coil the equilibrium is restored by putting the additional counter weight of mass $\Delta m=60 \mathrm{mg}$ on the balance pan. Find the magnetic induction at the spot where coil is located.
→The resistivity of a potentiometer wire is $40 \times 10^{-8} \mathrm{ohm}-\mathrm{m}$ and its area of cross-section is $8 \times 10^{-6} \mathrm{~m}^2$. If $0.2\ \mathrm{amp}$ current is flowing through the wire, the potential gradient will be
→Helium at $27^{\circ} \mathrm{C}$ has a volume of 8 litres. It is suddenly compressed to a volume of 1 litre. The temperature of the gas will be $[\gamma=5 / 3]$
→A vessel, whose bottom has round holes with diameter of $0.1 \mathrm{~mm}$, is filled with water. The maximum height to which the water can be filled without leakage is (S.T. of water $=75$ dyne $/ \mathrm{cm}, \mathrm{g}=1000 \mathrm{~cm} / \mathrm{s}$ )
→