Question
State uses and limitations of frequency modulation.
✓
Answer
- Frequency modulation (FM) is more complex as compared to amplitude modulation and, therefore is more difficult to implement.
- However, its main advantage is that it reproduces the original signal closely and is less susceptible to noise.
- This modulation is used for high quality broadcast transmission.
Need a full question paper?
Generate a complete, print-ready paper with questions like this in minutes — across 16+ boards, with answer keys.
Explore more
Similar questions
A metallic of diameter $0.02 m$ contains $10$ free electrons per cubic metre. Find the drift velocity for free electrons, having an electric current of $100$ amperes flowing through the wire.
$($Given: charge on electron $= 1.6 \times 10^{-19}C)$
→$($Given: charge on electron $= 1.6 \times 10^{-19}C)$
A charge of $5.0 C$ is kept at the centre of a sphere of radius $1 m.$ What is the flux passing through the sphere? How will this value change if the radius of the sphere is doubled?
→Explain the work-energy theorem in case of an accelerating conservative force along with a retarding non-conservative force.
A body is projected with a velocity of $30 \ ms^{-1}$ at an angle of $300$ with the vertical.
Find
$i)$ the maximum height
$ii)$ time of flight and
$iii)$ the horizontal range
→Find
$i)$ the maximum height
$ii)$ time of flight and
$iii)$ the horizontal range
Height of a TV tower is $600\ m$ at a given place. Calculate its coverage range if the radius of the Earth is $6400\ km.$ What should be the height to get the double coverage area?
→An electric circuit with a carton resistor and an electric bulb ( 60 watt, $300 \Omega$ ) are connected in series with a 230 V source.
i. Calculate the current flowing through the circuit.
ii. If the electric bulb of 60 watt is replaced by an electric bulb ( 80 watt, $300 \Omega$ ), will it glow? Justify your answer.
→i. Calculate the current flowing through the circuit.
ii. If the electric bulb of 60 watt is replaced by an electric bulb ( 80 watt, $300 \Omega$ ), will it glow? Justify your answer.
A composite wire is prepared by joining a tungsten wire and steel wire end to end. Both the wires are of the same length and the same area of cross section. If this composite wire is suspended to a rigid support and a force is applied to its free end, it gets extended by $3.25mm$. Calculate the increase in length of tungsten wire and steel wire separately.
[Given: $Y_{steel} = 2 \times 10^{11} Pa$, $Y_{Tungsten} = 4.11 \times 10^{11} Pa$]
→[Given: $Y_{steel} = 2 \times 10^{11} Pa$, $Y_{Tungsten} = 4.11 \times 10^{11} Pa$]
Draw a diagram showing different types of EM waves.
Which element would you use as an impurity to make germanium an n-type semiconductor?
A free pith ball of mass $5$ gram carries a positive charge of $0.6 \times 10^{-7} C.$ What is the nature and magnitude of charge that should be given to second ball fixed $6 \ cm$ vertically below the former pith ball so that the upper pith bath is stationary?
→