MCQ
In the circuit shown here, $E_1=E_2=E_3=2 V$ and $R_1=R_2=4$ ohms. The current flowing between points A and B through battery $E_2$ is
- AZero
- ✓2 amp from A to B
- C2 amp from B to A
- DNone of the above
✓
Answer
Correct option: B.
2 amp from A to B
(b) 2 amp from A to B
Need a full question paper?
Generate a complete, print-ready paper with questions like this in minutes — across 16+ boards, with answer keys.
Explore more
Similar questions
A meter bridge is set-up as shown, to determine an unknown resistance ' $X$ ' using a standard $10$ ohm resistor. The galvanometer shows null point when tapping-key is at $52 \ cm$ mark. The end-corrections are $1 \ cm$ and $2 \ cm$ respectively for the ends $A$ and $B$. The determined value of ' $X$ ' is
→The stopping potential is directly related to:
To charges $q_1$ and $q_2$ are placed 30 cm apart, shown in the figure. A third charge $q_3$ is moved along the arc of a circle of radius 40 cm from C to D. The change in the potential energy of the system is $\frac{\mathrm{q}_{\mathrm{g}}}{4 \pi \varepsilon_0} \mathrm{k}$, where k is
→What is the reading of voltmeter in the following figure
Two ideal slits $S_1$ and $S_2$ are at a distance d apart, and illuminated by light of wavelength $\lambda$ passing through an ideal source slit $S$ placed on the line through $S_2$ as shown. The distance between the planes of slits and the source slit is $D$. A screen is held at a distance $D$ from the plane of the slits. The minimum value of d for which there is darkness at $O$ is
→In an electromagnetic wave, the direction of the magnetic induction $B$ is
→Four lowest energy levels of H-atom are shown in the figure. The number of possible emission lines would be
Given below are two statement
→Statement$-I:$ A speech signal of $2\, kHz$ is used to modulate a carrier signal of $1\, MHz$. The band width requirement for the signal is $4\, kHz$
Statement$-II :$ The side band frequencies are $1002\, kHz$. and $998\, kHz$.
In the light of the above statements, choose the correct answer from the options given below
${10^{ - 3}}amp$ is flowing through a resistance of $1000\,\Omega $. To measure the correct potential difference, the voltmeter is to be used of which the resistance should be
→Two coherent sources separated by distance d are radiating in phase having wavelength l. A detector moves in a big circle around the two sources in the plane of the two sources. The angular position of n = 4 interference maxima is given as
