MCQ
Fly-wheel is used with an engine because it
- AIncreases the efficiency of engine
- BConverts linear motion into rotatory motion
- CIs compulsory by law
- ✓Makes the motion smooth and cuts down the vibrations
✓
Answer
Correct option: D.
Makes the motion smooth and cuts down the vibrations
d
(d)
(d)
Need a full question paper?
Generate a complete, print-ready paper with questions like this in minutes — across 16+ boards, with answer keys.
Explore more
Similar questions
A block of mass $m$ is placed on a smooth wedge of inclination $\theta $. The whole system is accelerated horizontally so that the block does not slip on the wedge. The force exerted by the wedge on the block ($g$ is acceleration due to gravity) will be
→Three conducting rods of same material and cross-section are shown in figure. Temperatures of$ A, D$ and $C$ are maintained at $20^o C, 90^o C$ and $0^o C$. The ratio of lengths of $BD$ and $BC$ if there is no heat flow in $AB$ is:
→Error in the measurement of radius of a sphere is $0.2\%$. The error in the calculated value of its volume is ......... $\%$
→The number of beats produced per second by two vibrations: $x_1 =x_0$ sin $646\pi t$ and $x_2 = x_0 sin 652 \pi t$ is
→Consider two sound sources $S_1$ and $s_2$ having same frequency $100\,\,Hz$ and the observer $O$ located between them as shown in the fig. All the three are moving with same velocity in same direction. The beat frequency of the observer is .... $Hz$
→A coin is placed on a horizontal platform which undergoes vertical simple harmonic motion of angular frequency $\omega $. The amplitude of oscillation is gradually increased. The coin will leave contact with the platform for the first time
→A particle is projected vertically upwards from $O$ with velocity $v$ and a second particle is projected at the same instant from $P$ (at a height h above $O$) with velocity $v$ at an angle of projection $\theta$ . The time when the distance between them is minimum is
→In the following fig. is shown the flow of liquid through a horizontal pipe. Three tubes $A, B$ and $ C$ are connected to the pipe. The radii of the tubes $A, B $ and $C$ at the junction are respectively $ 2 cm, 1 cm$ and $2 cm.$ It can be said that the
→A force $\vec{F}=4 t^3$ is applied on an object for the first two seconds. The linear momentum of object will increase.
→A vehicle of mass $m$ is moving on a rough horizontal road with momentum $P$. If the coefficient of friction between the tyres and the road be $\mu$, then the stopping distance is
→